Download Download Installation 1. Disconnect the negative cable from the battery. 2. Remove the trunk lid/fuel fill door opener cover (four retaining tabs and two hooks). Remove one self-tapping screw. Using the key, unlock the trunk lock. 3. Release the driver’s front door sill trim (seven clips, one hook, and two retaining tabs). 4. Pull away the door opening seal, and remove the driver’s kick panel (two clips). 5. Remove the driver’s dashboard lower cover (nine clips and unplug the vehicle connector). 6. Lower the tilt lever, and turn the steering wheel 90° counterclockwise. 7. Using a plastic trim tool, release the lock as shown. 8. Turn the steering wheel 180° clockwise. 9. Using a plastic trim tool, release the lock as shown. 10. Remove the upper column cover (four hooks). 11. Remove two self-tapping screws from the lower column cover. 12. Remove the lower column cover (one self-tapping screw). 13. Remove the front bumper: • Attach tape around the headlights as shown. • Wrap a shop towel around the hood latch. • Remove the 4 self-tapping screws, 10 short clips, and 2 long clips. • Release three retaining tabs on each side. • Release five retaining tabs on each side. • With the help of an assistant, remove the front bumper (two hex bolts and two clips). Place the front bumper on a blanket to prevent damage. 14. Remove six clips. 15. Pull back the right inner fender as shown. 16. Remove the front bumper absorber (two hooks).