Home Auto Repair 2007 Honda Civic Si Fog Lights Installation Instructions

2007 Honda Civic Si Fog Lights Installation Instructions

86

Download Installation 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. 3. Remove the radiator cover (four clips). 4. With the help of an assistant, remove the front bumper (six clips, two screws and four bolts). Set the front bumper on a blanket. 5. Apply masking tape to the front bumper around the left fog light area. 6. Using a utility knife, and working from the front of the bumper, carefully cut out the front bumper in the area shown. Take care not to damage the front bumper. Remove any burrs from the edges of the hole. 7. Repeat steps 5 and 6 to cut the bumper for the right fog light. 8. Using scissors, cut out the template. The template “L” is the mirror image of the template “R.” 9. Tape the template marked “L” to the inside of the front bumper below the left fog light opening. Using a pushpin, pierce the bumper through the mark in the template. 10. While wearing eye protection, drill a 10 mm hole through the bumper at the marked location. First drill with a 3 mm drill bit and finish with a 10 mm drill bit. 11. Repeat steps 9 and 10 to mark and drill the right side of the front bumper. 12. Position the left bracket on the left fog light, and install the two stepped screws and one washer screw. Tighten the screws securely. 13. Inside the front bumper, slide the left fog light into the cutout you made, and secure it with three self-tapping screws.