Home Auto Repair 2009 Honda Civic Fog Lights Installation Instructions

2009 Honda Civic Fog Lights Installation Instructions

68

Download Installation 1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped), then write down the radio presets. 2. Disconnect the negative cable from the battery. 3. Remove the radiator cover (two expansion clips and two clips). 4. With the help of an assistant, remove the front bumper (six clips, two self-tapping screws, two socket bolts and two bumper bolts). To prevent damage, set the front bumper on a blanket. 5. Remove the left fog light cover (five pawls). 6. Install the two spring nuts onto the front bumper. 7. Install the left fog light to the fog light cover opening, and secure it with two self-tapping screws. 8. Repeat steps 5 through 7 on the other side. 9. Route the fog light harness 2-pin connector between the lower grille and the front bumper from the right side through the left side. 10. Plug the fog light harness 2-pin connector into the left fog light connector. 11. Install the fog light harness clip onto the lower grille rib. 12. Plug the fog light harness 2-pin connector into the right fog light connector. 13. Install the fog light harness clip onto the lower grille rib. 14. Secure the fog light harness to each rib of the lower grille with one wire tie. 15. Remove three bolts from the washer tank. 16. Locate the 1-pin connector blue-taped to the vehicle harness and remove the blue tape to free the connector. Plug the vehicle 1-pin connector into the sub harness 1-pin connector.