Home Auto Repair 2013 Honda Civic XM Radio System Installation Instructions

2013 Honda Civic XM Radio System Installation Instructions

73

Download INSTALLATION 1. Disconnect the negative cable from the battery. 2. Remove the passenger’s sunvisor holder. 3. Wrap the end of a flat-tip screwdriver with tape. Locate the slot in the bracket cover, and insert a flat- tip screwdriver into the slot. Push the hook with the flat-tip screwdriver. 4. While pushing in on the hook, rotate the passenger’s sunvisor backward about 45°. Make sure the hook slides into the bracket cover. NOTE: If the hook did not stay pushed in, return the passenger’s sunvisor to its original position and repeat steps 3 and 4. 5. Remove the passenger’s sunvisor. 6. Pull away the passenger’s door opening seal. 7. Pull out the passenger’s A-pillar trim to release the clips. 8. Pull away the passenger’s door opening seal. 9. Pull out the passenger’s A-pillar trim to release the clips. 10. Put a shop towel in the opening between the passenger’s A-pillar trim and the dashboard to prevent dropping the A-pillar clips. Take care not to damage the passenger’s A-pillar trim. 11. Remove the passenger’s A-pillar trim from the upper clip (unplug the vehicle connector, if equipped). Carefully remove the shop towel and any clips that fell from the passenger’s A-pillar trim. NOTE: The upper clip will stay in the body. 12. Remove the remaining upper clip from the passenger’s A-pillar. 13. Install the new clip (supplied) to the passenger’s A-pillar trim. NOTE: When reinstalling the A-pillar trim, refer to the service manual for the correct overlap procedure