Home Auto Repair 2012 Honda Civic Ambient Lights Installation Instructions

2012 Honda Civic Ambient Lights Installation Instructions

74

Download Installation 1. Disconnect the negative cable from the battery. 2. Remove the glove box: • Remove two bolts. • Open the glove box. Push inward on the stops, and remove the glove box. 3. Attach tape in the areas shown. NOTE: Do not remove the tape until you have reinstalled the parts. 4. Remove two self-tapping screws from the center lower panel. 5. Remove the center lower panel (three clips, one retaining tab, and unplug the vehicle connectors). 6. Remove the driver’s dashboard lower cover (nine clips and unplug the vehicle connector, if equipped). Routing the Ambient Light Harness 7. Using isopropyl alcohol on a shop towel, clean the fuse case where the fuse label will attach. 8. Attach the 2A fuse label to the fuse case on the ambient light harness. 9. Locate the green tape on the ambient light harness. Align the green tape on the ambient light harness with the hole in the instrument panel on the driver’s side of the vehicle. Using one wire tie, secure the ambient light harness to the instrument panel. 10. Secure the ambient light harness to the instrument panel with one additional wire tie. 11. Route the ambient light harness 2-pin connector toward the passenger’s side as shown. 12. Using one wire tie, secure the ambient light harness to the vehicle frame. 13. At the center lower panel opening, secure the ambient light harness to the vehicle harness with one wire tie. 14. Continue routing the ambient light harness to the passenger’s side of the vehicle as shown. 15. Using one wire tie, secure the ambient light harness to the vehicle frame