Download Installation NOTE: • This aluminum wheel is designed for use on a vehicle equipped with TPMS (Tire Pressure Monitoring System). • This aluminum wheel is equipped with a TPMS sensor. See the service manual for the tire replacement procedure and TPMS sensor installation procedure. • The illustrations of the aluminum wheels are shown for reference purposes only. • Install the correct size tire. • Follow the instructions in the owner’s manual when jacking up the vehicle and removing and installing the wheels. Do not overtighten the wheel nuts. Wheel nut torque: 108 N·m (11 kgf·m, 80 lbf·ft). • Use a tire changer to install and remove the tires as described in the Operation Manual furnished with the tire changer. Do not use a tire lever to install and remove the tires as it may damage the tire and the aluminum wheel. 1. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 2. Remove the valve cap. Install the tire pressure sensor assembly and the washer onto the aluminum wheel, and finger tighten the valve nut. Make sure the tire pressure sensor assembly is resting on the wheel. 3. Tighten the valve nut to the specified torque while holding the tire pressure sensor assembly against the wheel. Reinstall the valve cap. Valve nut torque: 4.0 N·m (0.4 kgf·m, 3.0 lbf·ft). NOTE: Install the tire pressure sensor assembly so that the sensor housing surface does not protrude into the bead area of the wheel. 4. Install the tires according to the instructions in the service manual.