Home Auto Repair 2007 Honda Civic XM Radio System Installation Instructions

2007 Honda Civic XM Radio System Installation Instructions

115

Download Installation 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2.  Disconnect the negative cable from the battery. 3. Remove the passenger’s dashboard under cover (four clips, and two pins). 4. Remove the two bolts under the glove box. 5. Open and remove the glove box (two stops). 6. Remove the driver’s dashboard lower cover (eight clips). 7. Remove the inside cover from the front console pocket (two tabs). 8. Lower the tilt lever, then pull the steering wheel toward you. 9. To protect the dashboard area, put shop towels. 10. Apply masking tape to the meter panel as shown, and remove the meter panel (one self-tapping screw, 11 clips, and vehicle connectors). 11. Apply masking tape to the instrument panel as shown. Remove the center panel (two bolts, ten retaining clips, vehicle connectors and aspirator hose). 12. Remove the weatherstrip in the area shown. 13. Push the clip into the vehicle side by striking the top of the right front pillar trim in the part marked “SIDE CURTAIN AIRBAG” with the rubber mallet. Remove the clip. 14. Remove the weatherstrip in the area shown. Then remove the right front pillar trim (two clips). 15. Remove the cap from the right sunvisor (four retaining tabs). 16. Remove the right sunvisor (two T25 TORX screws, and unplug the vehicle connector). 17. Remove the sunvisor holder. Turn the holder 90°, then pull it out.