Home Auto Repair 2009 Honda Civic Si CD Changer Installation Instructions

2009 Honda Civic Si CD Changer Installation Instructions

73

Download Installation 1. Make sure you have the anti-theft codes for the audio unit and navigation system (if equipped), then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Remove the passenger’s dashboard lower cover (four clips and two pins). 4. Remove the driver’s dashboard lower cover (eight clips). 5. Remove the inside cover from the front console pocket (two tabs). 6. Lower the steering wheel lever and pull the steering toward you. 7. To protect the dashboard area, place a shop towel over the steering wheel and shift lever. 8. Apply masking tape to the instrument panel as shown, and remove the instrument panel (one self-tapping screw, 11 clips, and one connector). 9. Apply masking tape to the instrument panel as shown, and remove the center panel (two bolts,10 clips, and unplug the vehicle connectors). 10. Remove the two seat track end covers from the rear side of the passenger’s seat, then remove the two bolts that secure the passenger’s seat. 11. Remove the center console cover: • Pull down on the shift boot. Remove the shift knob by turning it counterclockwise. • Remove the center console cover by removing the five clips fastening the center console cover. 12. Open the center console lid, and remove the mat. 13. Remove the center console (four bolts, two clips, and the vehicle connector). 14. Inside the passenger’s compartment, remove the rear seat cushion by removing the bolt and releasing the two hooks.