Home Auto Repair 2007 Honda Civic Hybrid XM Radio System Installation Instructions

2007 Honda Civic Hybrid XM Radio System Installation Instructions

69

Download Installation 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. 3. Remove the passenger’s dashboard lower cover (four clips, and two pins). 4. Remove the two bolts under the glove box. 5. Open the glove box. Release the stops and remove the glove box. 6. Remove the driver’s dashboard lower cover (eight clips). 7. Remove the inside cover from the front console pocket (two tabs). 8. Lower the tilt lever and pull the steering wheel toward you. 9. To protect the dashboard area, place shop towels over the steering wheel and shift lever. 10. Apply masking tape to the meter panel as shown, and remove the instrument panel (one self-tapping screw, 11 clips, and two connectors). 11. Pull the aspirator hose off the air conditioner sensor. 12. Apply duct tape to the instrument panel as shown, and remove the center panel (two bolts, 11 retaining clips, and unplug the vehicle connectors). 13. Remove the weatherstrip from the opening edge of the right front pillar in the area shown. 14. Push the clip into the vehicle side by striking the top of the right front pillar trim on the part marked “SIDE CURTAIN AIRBAG” with the rubber mallet. Then remove the clip. 15. Remove the weatherstrip in the area shown. Remove the right front pillar trim (two clips). 16. Remove the cap from the right sunvisor (four retaining tabs). 17. Remove the right sunvisor (two T25 Torx screws, and unplug the vehicle connectors). 18. Remove the sunvisor holder.