Home Auto Repair 2012 Honda Crosstour Roof Racks Installation Instructions

2012 Honda Crosstour Roof Racks Installation Instructions

57

Download Installation NOTE: • Be careful not to damage the roof and other finished surfaces of the body when installing the roof rack. • The weight of the cargo must not exceed the maximum weight capacity of 50 kg (110 lbs). • Wipe the vehicle roof moldings clean before installing the roof rack. • The roof rack cannot be installed with the moonroof visor. Modifying the Roof Molding 1. Measure forward from the rear of the roof molding, and mark the roof molding at the measurement shown. 2. Using a plastic trim tool, pry up the edge of the roof molding in the areas shown. 3. Pull the roof molding toward the outside of the vehicle to release the locking tabs, press the locking tabs towards the inside of the vehicle, and remove the roof molding from the vehicle. When removing the roof molding, start from the rear of vehicle and work toward the front. 4. Release the pin. 5. Tie a shop towel around the rear edge of the roof molding to avoid scratching the roof. 6. Place a blanket over the roof of the vehicle under the mark on the roof molding. 7. Place an empty cardboard box (approx. 120 mm tall) under the roof molding near the mark. 8. While wearing eye protection, use an air saw to cut the roof molding at the mark. Do not use a cutting wheel or shears to cut the roof molding, it will damage the roof molding. Have an assistant hold the rear edge near the shop towel while cutting. 9. Remove the cardboard box and blanket.