Home Auto Repair 2012 Honda Crosstour Splash Guards Installation Instructions

2012 Honda Crosstour Splash Guards Installation Instructions

75

Download Installation NOTE: • These instructions show the left splash guards being installed. The same procedure applies to installing the right splash guards. • Clean and wax the areas to be covered with a high-quality paste wax. • The splash guards cannot be installed if the vehicle is equipped with a rear under spoiler Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Using a pushpin, pierce the center of the vehicle clip in the left front inner fenderwell. 3. Remove three self-tapping screws from the left front inner fenderwell. 4. Secure the left front splash guard by tightening the three self-tapping screws (reused) and one 5 x 25 mm self-tapping screw (provided), in the order shown. 5. Turn the steering wheel fully clockwise and repeat steps 2 thru 4 to install the right front splash guard. Installing the Rear Splash Guards 6. Remove and discard the three self-tapping screws from the left rear inner fenderwell. 7. Secure the left rear splash guard with two 5 x 25 mm self-tapping screws and one 5 x 20 mm self-tapping screw, in the order shown. NOTE: Make sure there is no gap between the left rear splash guard and the vehicle body. If there is a gap, loosen the three self-tapping screws, hold the splash guard against the body, and retighten the screws. 8. Repeat steps 6 and 7 to install the right rear splash guard.