Home Auto Repair 2012 Honda Crosstour Body Side Moldings Installation Instructions

2012 Honda Crosstour Body Side Moldings Installation Instructions

104

Download Installation • If you are also installing door edge films (sold separately), install them before you install the body side moldings. • These installation instructions show the left body side moldings being installed. The same procedure applies to the right body side moldings. • Be careful not to damage the paint finish. • This body side moldings kit should be installed only if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Please advise the customer. 1. Fold down the two tabs on the front template. 2. Insert the two tabs on the front template around the rear edge of the left front door. 3. Align the front template with the character line on the left front door, and attach the front template to the left front door using strips of masking tape. 4. Fold down the three tabs on the rear template. 5. Insert the three tabs on the rear template around the front edge of the left rear door. 6. Align the rear template with the character line on the left rear door, and attach the rear template to the left rear door using strips of masking tape. NOTE: Be sure that the bottom edges of the front and rear templates are aligned. 7. Using two alcohol wipes, clean the door surfaces below the templates where the body side moldings will attach. Allow the alcohol to dry. 8. Peel back about 40 to 50 mm (1½ to 2 in.) of adhesive backing from each adhesive tape, and tape the ends to the front surface of the left front body side molding.