Home Auto Repair 2012 Honda Crosstour Trailer Hitch Installation Instructions

2012 Honda Crosstour Trailer Hitch Installation Instructions

68

Download Installation • Install the backup sensor first when both the backup sensor and the trailer hitch are to be mounted on the vehicle. • This trailer hitch kit cannot be installed on a vehicle equipped with a rear under spoiler. 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. If equipped, remove the rear shelf. 4. Remove the cargo floor rear lid, cargo floor left lid, and cargo floor right lid. 5. Using a plastic trim tool, pry open the screw cover. Remove the tie down hook (one screw). Remove the other tie down hook the same way. 6. Fold down the rear seat back. Remove the cargo floor front lid (three clips). 7. Remove the cargo box. 8. Using a plastic trim tool, pry open the bolt cover, and remove the left cargo tray bolt. 9. Remove the left cargo tray (two clips). 12. Pull out on the two knobs to release the two hooks, and remove the rear seat cushion. 13. Remove the left rear seat side bolster (one bolt and two hooks). 14. Fold down the left rear seat back. Remove the one clip from the left rear side liner. 15. Remove the left cover (three clips and four tabs). 16. Using a plastic trim tool, remove the tie down hook cover. Remove the tie down hook (one bolt). 17. Using a plastic trim tool, remove the left side liner plastic cover. Remove the two screws under the cover. 18. Pull away the weatherstrip around the left rear side liner.