Home Auto Repair 2012 Honda Fit B-Pillar Trim Installation Instructions

2012 Honda Fit B-Pillar Trim Installation Instructions

85

Download 2012 Honda Fit B-Pillar Trim Installation Instructions Installation NOTE: • Be careful not to damage the paint finish. • This B-pillar trim kit should be installed only if the ambient air temperature is above 15°C (60°F). • To allow the adhesive to cure, do not wash the vehicle for 24 hours. • These installation instructions show the left B-pillar trim being installed. The same procedure applies to installing the right B-pillar trim. Installing the Front B-pillar Trim 1. Using an alcohol swab, thoroughly clean the area where the left front B-pillar trim will attach. 2. Peel back about 3 inches of adhesive backing from the left front B-pillar trim and fold it up diagonally as shown. Align the left front B-pillar trim on the left B-pillar as shown. While applying pressure on the trim, carefully remove the adhesive backing. 3. Using a rubber roller, apply pressure to set the adhesive. Installing the Rear B-pillar Trim 4. Using an alcohol swab, thoroughly clean the area where the left rear B-pillar trim will attach. 5. Repeat step 2 to install the left rear B-pillar trim. 6. Using a rubber roller, apply pressure to set the adhesive. 7. Repeat the steps 1 through 6 to install the right B-pillar trim.