Home Auto Repair 2012 Honda Fit Door Visors Installation Instructions

2012 Honda Fit Door Visors Installation Instructions

84

Download Installation Installing the Rear Door Visor. 1. Fully open the left rear window. 2. Pull out the upper corner of the run channel. 3. Open the run channel as shown, and measure where the EPT sealer (long) will attach. 4. Using isopropyl alcohol, clean the area where the EPT sealer (long) will attach. 5. Remove an EPT sealer (long) from the adhesive backing, and attach it as shown. Make sure it is attached securely. 6. Reinstall the run channel. Make sure it is installed correctly. 7. Slide the left rear quarter trim forward slightly to release the two retaining tabs. Do not try to remove the left rear quarter trim, the clip is easily damaged. 8. Pull out the rear corner of the run channel. 9. Using isopropyl alcohol, clean the area where the EPT sealer (short) will attach. 10. Remove an EPT sealer (short) from the adhesive backing, and attach it as shown. Make sure it is attached securely. 11. Reinstall the run channel and left rear quarter trim. Make sure the run channel is installed properly. 12. Pull down the run channel in the areas shown. 13. Install two brackets G to the door sash at the measurements shown. 14. Reinstall the run channel. Make sure the brackets G are installed correctly against the door sash as shown. 15. Using isopropyl alcohol, clean the door sash where the left rear door visor will attach. 16. Remove the adhesive backing from two sealers, and attach them to the left rear door as shown.