Home Auto Repair 2012 Honda Ridgeline Door Visors Installation Instructions

2012 Honda Ridgeline Door Visors Installation Instructions

94

Download Installation NOTE: • These instructions show the left door visors being installed; use the same procedure to install the right door visors. • Be careful not to damage the paint finish and the glass run channels when installing the door visors. • Handle the door visors with care. They are not designed to absorb shock or impact. • This door visor kit should be installed only if the ambient air temperature is above 60°F (15°C). • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Installing the Front Door Visor 1. Lower the front door glass completely. Remove the door glass run channel from the door sash in the area shown. Do not remove the glass run channel from the door mirror base. 2. Using isopropyl alcohol on a shop towel, clean the shaded area of the door sash. 3. Locate the door sash in the area where the EPT sealer will attach. Using isopropyl alcohol on a shop towel, thoroughly clean the area. 4. Trial fit the door visor to the door, and note the position that the EPT sealer needs to be installed in to seal and prevent wind noise. Remove the door visor. Remove the adhesive backing from the EPT sealer and attach it to the door mirror base as shown. 5. Attach masking tape to the ends of the long adhesive backings, and remove 2 to 3 in. (5 to 8 cm) from the ends. Fold back the ends and tape the ends to the front of the door visor. Note the direction of the adhesive backings. Remove the short adhesive backing. 6. Push the three door visor brackets onto the door sash and insert the front tab under the door mirror base.