Home Auto Repair 2012 Honda Ridgeline Rear Splash Guard Installation Instructions

2012 Honda Ridgeline Rear Splash Guard Installation Instructions

77

Download 2012 Honda Ridgeline Rear Splash Guard Installation Instructions Installation NOTE: • Do not damage the paint finish. • Wash and wax the areas to be covered. Use a high quality paste wax. 1. Remove two self-tapping screws from the rear bumper on the left side. 2. Remove one vehicle clip from the left rear inner fender. 3. While holding the left rear splash guard against the vehicle, secure the splash guard with a new clip. 4. Install the left rear splash guard with two self-tapping screws in the order as shown. Make sure that there is no gap between the rear bumper and the splash guard before tightening the screws. 5. Repeat steps 1 through 4 on the right side of the vehicle.