Home Auto Repair 2010 Honda Insight Door Visors Installation Instructions

2010 Honda Insight Door Visors Installation Instructions

74

Download Installing the Front Door Visor 1. Fully open the driver’s window. 2. Pull down the door glass run channel in the areas shown. 3. Install two brackets between the door sash and the run channel at the measurements shown. Seat the door glass run channel properly around the brackets. 4. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the left front door visor will attach. 5. Remove the adhesive backing from the seal, and attach it to the door sash. 6. Peel back approximately 1-1½ inches of adhesive backing from each adhesive tape, and tape the ends to the front surface of the left front door visor. 7. Align the clip holes in the visor with the bracket holes, and install two clips. There should be no clearance between the brackets and the door sash. 8. Adjust the left front door visor to the position shown. 9. While holding the door visor up firmly and back against the rear edge, remove the adhesive backing. Use your finger to push up each bracket so there is no gap between the brackets and the door sash. 10. Using a soft towel, press and hold the door visor against the door sash for 30 seconds. 11. Fully open the left rear window. 12. Pull down the glass run channel in the areas shown. 13. Install two brackets between the door sash and the run channel at the measurments shown. Seat the run channel properly around the brackets. 14. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the left rear door visor will attach.