Home Auto Repair 2010 Honda Insight USB Adapter Installation Instructions

2010 Honda Insight USB Adapter Installation Instructions

133

Download Installation 1. Make sure you have the anti-theft code for the audio unit. 2. Disconnect the negative cable from the 12 volt battery. 3. Remove the passenger’s undercover (three clips and two pins). 4. Remove the glove box (one damper rod, two bolts, and two stops). 5. Remove the center lower trim (six clips, three retaining tabs, and unplug the vehicle connector). 6. Remove the audio unit assembly: • Reach under the dashboard, and remove the audio unit bolt. • Using the sturdy wooden handle of a hammer, push the back of the audio unit forward to release the eight clips. • Release the harness clip, and unplug the vehicle connectors. Carefully remove the audio unit without scratching the dashboard. 7. Move the shift lever to the “D” position, and pull the parking brake lever all the way up. 8. Insert the key into the shift lock release slot, push down on the key, and move the shift lever to the “D” position. Pull the parking brake lever all the way up. 9. Remove the beverage holder. 10. Remove the rubber mat from the center console. 11. Remove the parking brake lever trim (two retaining tabs and one hook). 12. Attach masking tape to the bottom edge of the instrument panel, around the shift lever, and the parking brake lever. 13. Carefully remove the center console (two clips and two screws). 14. Remove the rear bolt from the vehicle frame, and release the harness clip. 15. Position the control unit bracket under the floor carpet as shown.