Home Auto Repair 2012 Honda Odyssey Full Nose Mask Installation Instructions

2012 Honda Odyssey Full Nose Mask Installation Instructions

74

Download Installation NOTE: • Make sure the vehicle and the nose mask are clean and completely dry before installation. If the moisture under the mask is allowed to dry, it may cloud the paint. If the mask becomes wet, remove it and allow it to air-dry completely. • Make sure any repainted surfaces are cured. • Wax the hood and nose of the vehicle with a high-quality paste wax. • Install the nose mask securely. If the nose mask starts to flap or comes loose while driving, safely pull to the side of the road, stop the vehicle, and re-secure or remove the mask. Please advise the customer Installing the Hood Section 1. Open the hood. Fit the corners of the mask around the hood. Adjust the mask so that it fits smoothly over the edges. Attach the four hooks to the hood by inserting your finger or thumb into the belt of each hook. Installing the Bumper Section 2. Slip the pocket on the mask onto the front corner of the left front fender. 3. Secure one hook to the vehicle frame. 4. Pull the mask back toward the fenderwell, smooth out any wrinkles, and secure five hooks to the fenderwell. 5. Insert five tabs below the left headlight. 6. Repeat steps 2 thru 5 to install the mask on the right side of the vehicle. 7. Route the elastic cord through eight loops on the bottom of the mask. 8. Secure one end of the elastic cord to the inner fender hole. 9. Make sure the elastic cord is routed through all the loops, and attach the other hook to the inner fender on the other side of the vehicle.