Home Auto Repair 2011 Honda Odyssey Remote Control Engine Starter Installation

2011 Honda Odyssey Remote Control Engine Starter Installation

71

Download Installation NOTE: This antenna should only be installed if the ambient air temperature 15°C (60°F) or above. 1. Make sure you have the anti-theft code for the audio unit and navigation system (if equipped), then write down the radio station presets. 2. Move the driver’s seat all the way back. 3. Remove the air duct (two clips). 4. Disconnect the negative cable from the battery. Setting the Control Unit : 5. Touch the metal part of the screwdriver to any metal part of the vehicle to discharge any static electricity. 6. Using a small flat-tip screwdriver, change the switches on the control unit to the setting shown above. 7. Using isopropyl alcohol on a shop towel, clean the area where the protective tape will attach. Attach the protective tape to the control unit over the switches. 8. Remove the roof console. • Using a small flat-tip screwdriver wrapped with a shop towel, pry out and remove the left and right lens (four retaining tabs each). • Open the sunglass holder and remove the four screws. • Remove the roof console (unplug the vehicle connectors). 9. Rotate the sunvisor holders 45° counterclockwise and remove the two sunvisor holders. 10. Remove the driver’s sunvisor. • Turn the sunvisor toward the driver’s seat. • Locate the slot in the sunvisor holder, and insert a flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate toward the door to remove.