Download Installation 1. Make sure you have the anti-theft code for the audio unit and navigation system (if equipped), then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Remove the roof console. • Using a small flat-tip screwdriver wrapped with a shop towel, pry out and remove the left and right lenses (four retaining tabs each). • Open the sun glass holder and remove the four screws. • Remove the roof console (unplug the vehicle connectors). 4. Rotate each sun visor holder 45° counterclockwise, then remove it. 5. Loosen the torx screw, and remove the mirror. 6. Install the automatic day/night mirror on the mirror mount as shown, and tighten the torx screw. 7. Route the automatic day/night mirror harness as shown. Plug the automatic day/night mirror harness 7-pin connector to the automatic day/night mirror. 8. Align the green tape on the automatic day/night mirror harness to the edge of the headliner. 9. Secure the automatic day/night mirror harness to the vehicle harness with one wire tie. Secure the wire tie beside the vehicle clip. 10. Remove the blue tape to release the vehicle 6-pin connector. 11. Plug the automatic day/night mirror harness 6-pin connector to the vehicle 6-pin connector. 12. Wrap one EPT sealer around the 6-pin connectors and vehicle harness. 13. Secure the 6-pin connectors and vehicle harness with one wire tie. 14. Install the harness cover.