Home Auto Repair 2011 Honda Accord 19” Aluminum Wheel Installation Instructions

2011 Honda Accord 19” Aluminum Wheel Installation Instructions

77

Download 1. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the center cap emblem will attach. 2. Remove the adhesive backing from the center cap emblem. 3. Align the pins with the holes, and attach the center cap emblem to the wheel center cap. After attaching, hold the emblem firmly against the wheel center cap with the palm of your hand for 30 seconds. 4. Slide the push nuts onto the pins. Note the direction of the push nuts. 5. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the aluminum wheel. 6. Install the tire pressure sensor and the washer to the aluminum wheel, and finger-tighten the valve nut. Make sure the pressure sensor is resting on the wheel. 7. Tighten the valve nut to the specified torque while holding the tire pressure sensor against the wheel. Tightening torque: 4 N·m (0.4 kgf·m, 3 lbf·ft) NOTE: • To prevent the sensor housing from being caught on the bead when mounting the tire, install the tire pressure sensor so that the sensorhousing surface does not protrude into the bead area of wheel . • Do not reuse any grommet that has been tightened, even one time, to the specified torque, as it is deformed inside. • Do not use pneumatic or electric tools on the valve nut. • Tightening the nut over the specified torque can damage the grommet. 8. Install the tires according to the instructions in the service manual.