Home Auto Repair 2013 Honda Pilot Trailer Harness Installation Instructions

2013 Honda Pilot Trailer Harness Installation Instructions

56

Download Installation NOTE: 1. Make sure you have the anti-theft code for the audio unit and the navigation system (if equipped), then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Remove the left third row seat: • Open the rear hatch, and remove the rear cargo tray (ten clips). • Use a small flat-tip screwdriver, to push on the buckle to release the seat belt lower hook from the left third row seat. • Remove the two front seat bolt covers from the left third row seat (two retaining tabs for each cover). • Remove the two front seat bolts from the third seat cushion, then raise the third seat cushion assembly. • Tilt the left third row seat cushion assembly up, route for two seat belt buckles through the opening in the left third row seat. • With the left third row seat cushion assembly still tilted up, remove the remaining four seat bolts. Remove the left third row seat. NOTE: When reinstalling the third row seat, apply Honda locktite to seat bolt threads and torque the seat bolts to 41-53 N·m (30-39 lbf·ft) 4. Remove the left rear side step (four clips). 5. Using the plastic trim tool, open the two tie-down hook covers. Remove two tie-down hooks from the left rear side trim panel (one screw for each cover). 6. Pull away the weatherstrip and door opening seal at the front and rear of the left rear side trim panel. Remove the left rear side trim panel (six clips).