Home Auto Repair 2011 Honda Civic Interior Illumination Installation Instructions

2011 Honda Civic Interior Illumination Installation Instructions

80

Download Installation 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. If equipped, remove the driver’s dashboard under cover (turn the knob counterclockwise, and release two clips and pin). 4. Remove the driver’s dashboard lower cover (eight clips). 5. Lower the tilt lever, and move the steering wheel to its lowest position. After moving the steering wheel, return the tilt lever to its original position. 6. Cover the combination light switch, wiper/washer switch, and shift lever with shop towels to protect them from damage. 7. Apply masking tape to the dashboard. Remove the instrument panel (one self-tapping screw and 11 clips), and unplug the vehicle connector. 8. Shift to “S” or “2”, and remove the lid from the dashboard center lower cover (four retaining tabs). 9. Remove the passenger’s dashboard under cover (four clips and two pins). 10. Remove the two bolts. Open the glove box, push inward on the stops, and remove the glove box. 11. Route the interior illumination light harness 5-pin connector behind the fuse box, and pull it out through the opening of the air duct. 12. Measure the vehicle harness from the point of the branch as shown. Secure the interior illumination light harness (6-pin connector side) to the vehicle harness with one wire tie. 13. Plug the interior illumination light harness 6-pin connector into the fuse box 6-pin connector. 14. Route the two interior illumination light harness 2-pin connectors to the right side of the vehicle along the vehicle harness.