Home Auto Repair 2012 Honda Civic Wing Spoiler Installation Instructions

2012 Honda Civic Wing Spoiler Installation Instructions

84

Download Installation 1. Disconnect the negative cable from the battery. 2. Open the trunk lid. If equipped, remove the trunk lid trim panel (11 clips). Installing the Wing Spoiler 3. Close the trunk lid. Attach masking tape to the trunk lid as shown. 4. Align the edge of the template to the edge of the trunk lid as shown, and attach it with masking tape. 5. Using a felt-tip pen, mark three holes on the masking tape through the template. 6. Remove the template. 7. Turn the template over. Align the edge of the template to the edge of the trunk lid as shown, and attach it with masking tape. 8. Using a felt-tip pen, mark two holes on the masking tape through the template. 9. Remove the template. 10. Using a center punch, mark the centers of the five marks. Set the center punch to the minimum power setting. 11. While wearing eye protection, drill four 8 mm holes through the marks. First drill with a 3 mm drill bit, then with a 6 mm drill bit, and finish with an 8 mm drill bit. Drill perpendicularly to the trunk lid. • To prevent drilling through the inner panel, wrap tape around the drill bit 10 mm (0.4 in.) away from the tip. • Take care not to damage the wire harnesses when drilling the holes. 12. While wearing eye protection, drill a 10 mm hole through the remaining mark. First drill with a 3 mm drill bit, then with a 6 mm drill bit, and finish with a 10 mm drill bit. Make sure to drill perpendicularly to the trunk lid. • To prevent drilling through the inner panel, wrap a strip of tape around the drill bits 10 mm (0.4 in.) away from the tip.