Home Auto Repair 2013 Honda Accord Remote Control Engine Starter Installation

2013 Honda Accord Remote Control Engine Starter Installation

84

Download Installation NOTE: This antenna should be installed only if the ambient air temperature is 15°C (60°F) or above. 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. Setting the Control Unit 3. Using a small flat-tip screwdriver, set the switches on the (accessory) control unit to the positions shown. Using isopropyl alcohol on a shop towel, clean the area where the protective tape will attach. Remove the adhesive backing, and attach the protective tape to the control unit. 4. Remove the driver’s dashboard lower cover (eight clips, two hooks, and disconnect the vehicle connector). 5. V6 Model only: remove the driver’s dashboard under cover (three clips and one pin). 6. Remove the cover from the trunk lid/fuel fill door opener (six retaining tabs), and remove one self-tapping screw. Make sure the trunk lid/fuel fill door opener is unlocked. 7. Lift the front portion of the left front door sill trim to remove it (six clips, one retaining tab, and one hook). 8. Pull away the weatherstrip, and remove the left kick panel (two clips). 9. Pull away the weatherstrip and remove the left dashboard side cover (seven retaining tabs and three hooks). 10. Lower the tilt lever and pull the steering wheel out. 11. Remove the steering column upper cover: • Insert a flat-tip screwdriver along the column guide inside the lower cover,