Home Auto Repair 2011 Honda Civic Si Front Under Spoiler Installation Instructions

2011 Honda Civic Si Front Under Spoiler Installation Instructions

88

Download Without fog lights With fog lights: Go to step 3. 1. Remove the left cover (four pawls). 2. Repeat step 1 on the other side. Go to step 6. With fog lights 3. Remove one self-tapping screw. 4. Remove the left fog light (two pawls, two tabs, and vehicle connectors). 5. Repeat steps 3 and 4 on the other side. 6. Cut the template. Align template B on the front bumper. Using a pushpin, pierce the front bumper to make two marks as shown. 7. Remove template B. 8. Align template A on the front bumper. Using a pushpin, pierce the front bumper to make one mark as shown. 9. Remove template A. 10. While wearing eye protection, drill a 3 mm hole through the two marks on the front bumper as shown. Finish with a 12 mm bit. Wrap tape around the drill bit 10 mm away from the tip. 11. Remove any burrs from the edge of the hole. 12. Reverse templates A and B and repeat steps 6 thru 11 on the other side. 13. Turn the steering wheel clockwise. 14. Drill a 3 mm hole through the center of the two dimpled areas on the front bumper as shown. 15. Remove any burrs from the edges of the holes. 16. Slide two spring nuts over the two holes drilled in the front bumper. 17. Turn the steering wheel counterclockwise. Repeat steps 14 thru 16 on the other side. 18. Remove the two clips securing the front bumper. 19. Attach one sponge seal to each clip on the front under spoiler as shown. 20. Attach a strip of masking tape to the end of each backing, and peel back 30 to 40 mm of the backings. Fold the ends back, and tape them to the front of the front under spoiler.