Home Auto Repair 2007 Honda Civic Trunk Spoiler Installation Instructions

2007 Honda Civic Trunk Spoiler Installation Instructions

67

Download Installation NOTE: • Be careful not to damage the body paint finish. • This trunk spoiler kit should be installed only if the ambient air temperature is 60°F (15°C) or above. • Wash and wax the area to be covered with a high quality paste wax. Installing the Rear Wing Spoiler 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. 3. Open the trunk lid. If equipped, remove the hinge arm cover (two clips). 4. If equipped, remove the trunk lid cover (eight clips). 5. On the inside of the trunk lid, locate the identification marks on the trunk lid. Lightly center-punch the mark. Repeat on the right side of the trunk lid. 6. While wearing eye protection, drill an 8 mm hole through each mark. • To prevent the metal shavings from falling onto the trunk floor, place a cover over the trunk floor. • First drill with a 3 mm drill bit, then finish with an 8 mm drill bit. • Remove all burrs and metal shavings, and apply touch-up paint to the edges of the holes. • When the touch-up paint is dry, clean the area to be covered, and wax it with a high-quality paste wax. • Repeat on the right side of the trunk lid. 7. Mark the trunk lid stopper with a felt-tip pen, then turn it to the counterclockwise to remove it. Repeat on the opposite side. 7. Mark the trunk lid stopper with a felt-tip pen, then turn it to the counterclockwise to remove it. Repeat on the opposite side. 7. Mark the trunk lid stopper with a felt-tip pen, then turn it to the counterclockwise to remove it. Repeat on the opposite side.