Home Auto Repair 2012 Honda CRV Moonroof Visor Installation Instructions

2012 Honda CRV Moonroof Visor Installation Instructions

64

Download Installation NOTE: • Do not damage the paint finish when you install the moonroof visor. • The moonroof visor should only be installed if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Please advise your customer. Installing the Moonroof Visor 1. Clean and wax the area to be covered with a high-quality paste wax. 2. Open the moonroof. Roll up two shop towels, and insert them between the roof panel and air deflector to lower the air deflector. Take care not to damage the air deflector. 3. Locate the indentation on the right side of the moonroof opening. Measure 50 mm (2.0 in.) toward the front of the vehicle, and make one mark on the roof panel. Repeat the same procedure on the left side of the vehicle. 4. Using isopropyl alcohol on a shop towel, clean the roof area where the protective tape will attach. Do not wipe off the mark. 5. Remove the adhesive backing from one protective tape, and attach it to the right side of roof panel from the mark. Wrap 10 mm (0.4 in.) of protective tape around the lip of the moonroof opening. Remove the mark. 6. Repeat steps 4 and 5 to install the protective tape on the left side of moonroof opening. 7. Locate the third indentation in from right side of the moonroof opening as shown. Using isopropyl alcohol on a shop towel, clean the roof area where the protective tape will attach. 8. Remove the adhesive backing from one protective tape.