Home Auto Repair 2013 Honda CRV Remote Control Engine Starter Installation

2013 Honda CRV Remote Control Engine Starter Installation

66

Download Installation NOTE: This antenna should only be installed if the ambient air temperature 15°C (60°F) or above. 1. Move the driver’s seat all the way back. 2. Disconnect the negative cable from the battery. Setting the Control Unit 3. Using a small flat-tip screwdriver, set the switches on the (accessory) control unit to the locations shown. NOTE: • The switches must be set before the control unit is plugged in. • If the switch settings are not correct, the remote engine starter will not operate correctly. • If setting the switches with the control unit installed in the vehicle, touch the metal part of the screwdriver to any metal part of the vehicle to discharge any static electricity. • If you change the switch settings with the unit connected, you must disconnect the unit, then reconnect it before the new settings are recognized. 4. Using isopropyl alcohol on a shop towel, clean the control unit where the protective tape will attach. Remove the adhesive backing, and attach the protective tape to the control unit over the switches. 5. Remove the roof console. • Using a plastic trim tool, pry out and remove the left and right lens (four retaining tabs each). • Open the sunglass holder and remove the four screws. • Remove the roof console (unplug the vehicle connectors). 6. Release the driver’s sunvisor and passenger’s sunvisor from the two sunvisor holders. 7. Rotate each sunvisor holders 45° counterclockwise to remove the two sunvisor holders.