Home Auto Repair 2012 Honda CRV Exhaust Pipe Finisher Installation Instructions

2012 Honda CRV Exhaust Pipe Finisher Installation Instructions

76

Download Installation NOTE: • Install the accessory with care not to damage the vehicle body and the parts of the vehicle. • The exhaust pipe finisher is designed exclusively for the CR-V, it is not applicable to the other models. • Allow the exhaust pipe to cool down before installing the exhaust pipe finisher. 1. Partially thread the washer-bolt into the exhaust pipe finisher. Slide the exhaust pipe finisher onto the exhaust pipe. 2. Continue to slide the exhaust pipe finisher in until it contacts the end of the exhaust pipe. While holding the exhaust pipe finisher firmly against the exhaust pipe, torque the washer bolt to 10 N·m (7 lbf·ft). 3. Start the engine, and rev it up a few times. Listen for vibration from the exhaust pipe finisher, and adjust if necessary. CLEANING THE EXHAUST PIPE FINISHER Use a sponge or cloth and a solution of mild liquid dishwashing soap and water to clean the exhaust pipe finisher. Wax the exhaust pipe finisher using Honda Metal Polish (08C20-A021S). Never use a wax that contains abrasive material as it may scratch the surface.