Home Auto Repair 1999 Audi A6 Quattro Sedan Front Bumper And Assembly Overview

1999 Audi A6 Quattro Sedan Front Bumper And Assembly Overview

149

Download 1999 Audi A6 Quattro Sedan V6-2.8l Front Bumper, Removing, Installing And Assembly Overview 1 – Bumper cover Removing: Front tires removed Front half of wheelhousing loosened. Unscrew flanged nuts – 10 – on both sides. Unscrew screw w/washer assembly – 6 – from wheelhousing liner – 5 -. Remove socket-head bolts – 7 – and remove bumper cover together with impact absorber toward front. Installing: NOTE: Before installing the bumper , the expanding clips must be pressed in to the fender. When installing the tabs, the bumper cover must latch into clip – 4 -. Latch bumper cover – 1 – into guide – 2 -. Tighten flanged nuts – 10 – to 6 Nm (53 in.lb) . Screw in socket-head bolt – 7 – and tighten to 23 Nm (17 ft lb) . NOTE : The impact absorber is installed vertical to the cross member and has height compensating elements. 2 – Guide 3 – Fender 4 – Clip When installing bumper cover – 1 -, tab must latch into clip – 4 – 5 – Wheelhousing liner 6 – Screw w/washer assembly 1 Nm (9 in.lb) 7 – Socket-head bolt Install after bumper installation Height adjustment to cross member is selfcompensating. 8 – Air inlet grill 9 – Air inlet grill 10 – Flanged nut 6 Nm (53 in.lb)