Download Tools Required J 38778 Trim Panel Remover Removal Procedure 1. Remove the door handle bezel. 2. Remove the window regulator handle, as necessary. 3. Disconnect the power accessory switch mounting panel wiring connector, as necessary. 4. Remove the trim panel upper extension. 5. Using a flatblade tool, carefully pry off the trim panel armrest screw cover in order to access the screw. 6. Remove the trim panel armrest screw. 7. Using the J 38778, carefully pry the retainer from the retainer seats. 8. Disconnect the courtesy light connector, if necessary. 9. Remove the trim panel from the door. 10. Remove the courtesy lamp lens or the reflector. 11. Pull the retainers from the slot in the trim panel. 12. Remove the retainers. Installation Procedure 1. Align the retainer with the slot in the trim panel. 2. Push to install the retainers to the trim panel. 3. Install the courtesy lamp lens or the reflector. 4. Align the retainers with the holes in the door. 5. Install the trim panel to the door by carefully applying pressure in order to seat the retainers. 6. Install the window regulator handle, as necessary. 7. Install the power accessory switch mounting panel, as necessary. Notice: Refer to Fastener Notice in Service Precautions. 8. Install the trim panel armrest screw. Tighten the trim panel armrest screw to 2 N.m (18 lb in). 9. Insert the screw cover. 10. Install the trim panel upper extension. 11. Install the door handle bezel.