Download Step 1: Remove the two bolts from the passenger facet engine mount. Marked “A” in picture 1. Step 2: Set up the Engine Bracket over the engine mount holes with the slender bolt flange to the rear and the broader bolt flange to the front.Step 3: Tighten bracket to the engine mount using the 2 longer, flanged head bolts in the hardware pack. See image 2 at left. Step four: Take away the 4 nuts from the passenger side upper strut mount. Marked “B” in picture 1. Step 5: Set up the Strut Bracket over the strut studs with the ETD mounting tab dealing with up and the notch within the bracket going across the A/C service port. You might must loosen the manufacturing facility strut brace at the firewall connection to get the bracket over the studs. Step 6: Set up the strut bracket using the four silver flanged nuts in the hardware package and tighten. Step 7: Install Stiffy™ onto the Strut Bracket and Engine Bracket using the supplied hardware. Begin on the Engine bracket. The supplied M10 (17mm HEX) bolt ought to go via the ETD rod finish first. Then place the rubber O-ring and washer over the bolt before inserting into the Engine Bracket. Use the black lock nut and tighten.