Download Toothed belt, removing and installing Special tools and equipment: – Spring pin from 2024A – Pin wrench 3212 – Open end wrench 3312 – Wrench 3078 (22 mm) – Clamping bolt 3242 – Camshaft bar T40005 – Puller T40001 – Torque wrench VAG 1410 – Socket attachment VAS 5122 – Tensioning roller key T40009 – Pin T40011 Removing – – – – Remove engine cover-arrows-. Remove cylinder head cover-1- and -2-. Disengage spring clips at toothed belt cover. Remove toothed belt cover. – – – Remove noise insulation -arrows-. Removing and installing ribbed belt. See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair Remove ribbed belt pulley for viscous fan. Turn crankshaft to TDC by hand. Markings -A- and -B- must be aligned. Check position of camshafts: larger holes -arrow- in securing plates on camshaft sprockets must be in line with each other and facing inward. If not, turn crankshaft one revolution. Remove sealing plug -arrow- from left side of cylinder block. TDC drilling in crankshaft must be behind sealing plug hole (feel to check).