Download CAUTION: Electronic modules are sensitive to static electrical charges. Avoid exposing any modules to static electrical charges, as this may cause damage to the modules. 1. Depower the Supplemental Restraint System (SRS). For additional information, refre to Supplemental Restraint System (SRS) Depowering and Repowering in Section 501-20B. 2. If equipped, remove the floor console. For additional information, refer to Floor Console in this section. 3. Position the speed control servo aside. 1. Disconnect the electrical connector. 2. Remove the nuts. 3. Position the speed control servo aside. 4. Disconnect the LH engine compartment in-line electrical connector. Release the wiring harness locators. 5. Disconnect the brake fluid sensor electrical connector. 6. Disconnect the windshield wiper motor electrical connector. Release the wiring harness locators. 7. Disconnect the LH engine compartment in-line electrical connectors. 8. Unseat the LH wiring harness grommet. 9. Disconnect the blower motor electrical connector. 10. Disconnect the A/C pressure cut-off switch electrical connector.