Home Auto Repair 2002 Suzuki Vitara JLS EVAP Control System Leak Detected (Small Leak)

2002 Suzuki Vitara JLS EVAP Control System Leak Detected (Small Leak)

143
Download NOTE: Check to make sure that the following conditions are satisfied when using this DTC CONFIRMATION PROCEDURE. – Intake air temperature: -8 °C (18 °F) or higher – Engine coolant temperature: -8 – 110 °C (18 – 230 °F) – Altitude (barometric pressure): 2400 m, 8000 ft or less (560 mmHg, 75 kPa or more) – Indication of fuel level meter in combination meter: Lower than 3/4 1. 2. 3. 4. 5. 6. Connect scan tool with ignition switch OFF. Turn ON ignition switch and clear DTC, pending DTC and freeze frame data by using scan tool and start engine. Increase vehicle speed to 55 km/h (35 mph) or more. keep driving above vehicle speed for about 20 min. (Change of vehicle speed is permitted in this step). keep driving 50 – 60 km/h (30 – 40 mph) for about 3 min (Throttle valve opening is kept constant in this step). Stop vehicle and check if DTC and pending DTC exists by using scan tool. If not, check if evaporative system monitoring test has completed by using scan tool. If not in both of above checks (i.e., no pending DTC and evaporative system monitoring test not completed), check vehicle conditions (environmental) and repeat Steps 3 through 6.