Home Auto Repair 2003 Ford Focus ZTW HUB/ STEERING KNUCKLE ASSEMBLY Removal

2003 Ford Focus ZTW HUB/ STEERING KNUCKLE ASSEMBLY Removal

194
Download 1. Loosen the strut tower nuts by at least five turns. See Fig. 4 . Loosen the wheel hub retaining nut. Raise and support vehicle. Remove front wheel, brake caliper and rotor. Remove ABS wheel speed sensor (if equipped). Remove tie rod end cotter pin and nut. Using Tie Rod End Separator (211-001), remove tie rod end. See Fig. 13 . 2. Remove lower control arm nut and pinch bolt. See Fig. 15 . Separate lower control arm from steering knuckle. Remove wheel hub retaining nut. Using a suitable puller, separate wheel hub from halfshaft. See Fig. 6 . Remove strut assembly-to-steering knuckle bolt. See Fig. 3 . Remove steering knuckle. Disassembly & Reassembly 1. Using Bearing Pulling Attachment (205-D064), press wheel hub from wheel knuckle. See Fig. 7 . Remove retainer ring from wheel knuckle. See Fig. 8 . Using a suitable drift, remove front wheel bearing from wheel knuckle. See Fig. 9 . CAUTION: