Home Auto Repair 2004 Audi A6 Front Bumper, Removing, Installing And Assembly Overview

2004 Audi A6 Front Bumper, Removing, Installing And Assembly Overview

205
Download 1 – Bumper cover Removing: Front tires removed Front half of wheelhousing loosened. Unscrew flanged nuts – 10 – on both sides. Unscrew screw w/washer assembly – 6 – from wheelhousing liner – 5 -. Remove socket-head bolts – 7 – and remove bumper cover together with impact absorber toward front. Installing: NOTE: Before installing the bumper, the expanding clips must be pressed in to the fender. When installing the tabs, the bumper cover must latch into clip – 4 -. Latch bumper cover – 1 – into guide – 2 -. Tighten flanged nuts – 10 – to 6 Nm (53 in.lb) . Screw in socket-head bolt – 7 – and tighten to 23 Nm (17 ft lb) . NOTE : The impact absorber is installed vertical to the cross member and has height compensating elements. Guide 3 – Fender 4 – Clip When installing bumper cover – 1 -, tab must latch into clip – 4 – 5 – Wheelhousing liner 6 – Screw w/washer assembly 1 Nm (9 in.lb) – Socket-head bolt Install after bumper installation Height adjustment to cross member is selfcompensating. – Air inlet grill – Air inlet grill 10 – Flanged nut 6 Nm (53 in.lb)