Home Auto Repair 2010 Kia Sorento Coolant Removal And Installation

2010 Kia Sorento Coolant Removal And Installation

144

Download 2010 Kia Sorento Coolant Removal And Installation – Removal 1. Drain the cooling 1lvaterto the bottom level ofthe gauge unit. 2. After disconnecting the tiatten,r ground caple, disconnect engine harness. 3. Remove the 1lvater temperature gauge unit and sensor. Inspection 1. Watertemperature gauge unit ‘1} Heat up the 1lvater temperature gauge ov immersing it in hot water. 2} Check ifthe resistance is within the specified range. Specified value: 50 “C [140 c’F] l125 ohms 55 “C [155 “F] i5.4 $5.5 ohms 11 [I “C [230 c’F]l21!|- +2.2 4.9 ohms 125 “C [25? “F1 i152 ohms 2. 1v’ll’atertemperature sensor l} Immerse the sensor in hot water. 2} Check ifthe resistance is within the specified range. Specified value: 20 “C [53 ElF] lid-5 £0.14 lt ohms 30 “C [1TB E’F] “3.322 k ohms l. Smear the sealant on thread and then tighten it to the specified toroue. 1I.i“l.iater temperature sensor: Recommended sealant: Loctite 952T or equivalent. Tightening tongue: 2U -4U Hrn 2. Connectthe harness to watertemperature gauge unit and cable. 3. Connectthe hatten,r ground cable. 4. Refill the coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .