Home Auto Repair 2015 Honda Fit Ambient Lights Installation Instructions

2015 Honda Fit Ambient Lights Installation Instructions

114

Download 2015 Honda Fit Ambient Lights Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Remove the passenger’s under cover. 3. Open the glove box, push inward on the stops, and remove the glove box. 4. Pull back the door opening seal, and remove the driver’s dashboard side lid. 5. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors. 6. Apply tape to the areas shown. 7. Remove the center lower cover, and unplug the vehicle connectors. 8. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the fuse label will attach. 9. Attach the fuse label to the ambient light harness fuse case. 10. Unplug the vehicle 14-pin connector, and plug it into the ambient light harness 14-pin connector. Plug the ambient light harness 14-pin connector into the vehicle 14-pin connector. 11. Align the green tape on the ambient light harness with the vehicle clip, and secure the ambient light harness to the vehicle harness with one wire tie. 12. Route the ambient light harness as shown. Then loosely secure the ambient light harness to the vehicle harness with one wire tie. 13. Install the bracket to the driver’s dashboard lower cover with one self-tapping screw. 14. Install the ambient light to the bracket with one self-tapping screw. 15. Plug the ambient light harness 4-pin connector into the ambient light, and reinstall the driver’s dashboard lower cover.