Download REMOVAL & INSTALLATION 1. Remove hood. 2. Remove front fender apron seals. 3. Drain engine coolant. 4. Drain engine oil. 5. Disconnect accelerator cable. 6. Remove air cleaner cap. a. Disconnect the Intake Air Temperature (IAT) sensor connector. b. Disconnect the Vacuum Switching Valve (VSV) connector for the Evaporative Emission (EVAP) c. Disconnect the cable and hoses: ● PCV hose from cylinder head cover ● EVAP hose from throttle body ● EVAP hose from VSV d. Disconnect the 2 clamps, and disconnect the air cleaner cap from the air cleaner case. e. Loosen hose clamp, and disconnect the air cleaner hose from the throttle body. f. Remove the air cleaner cap and hose assembly. 7. Remove air cleaner case. a. Remove the air filter. b. Remove the 3 bolts and air cleaner case. 8. Remove battery and tray. 9. Remove cruise control actuator. 10. Remove radiator. 11. Remove front exhaust pipe. a. Remove the 2 bolts holding the support stay to the support bracket. b. Remove the 2 bolts holding the support bracket to the front frame. c. Remove the 2 bolts and 2 nuts holding the front exhaust pipe to the center exhaust pipe. d. Remove the 3 nuts holding the front exhaust pipe to the exhaust manifold. e. Remove the front exhaust pipe and 2 gaskets.