Download Repair Procedure 1. Conduct a road test to verify the noise condition — front brake rattle noise will occur when the front tire runs over a depression in the road. 2. Remove and replace the front disc brake pad support plates (2 per each caliper). NOTE The procedures listed below are for one side and should be used for both the RH and LH side. A. Remove the front wheel. B. Remove the caliper by holding the front disc brake slide pin and removing the 2 bolts. C. Remove the 2 front brake pads from the front disc brake cylinder mounting. D. Remove the anti-squeal shims and the pad wear indicator plates from each pad. E. Remove the 2 front disc brake pad support plates from the cylinder mounting. F. Remove the front disc brake cylinder mounting by removing the 2 bolts. G. Install the NEW disc brake cylinder mounting with the 2 bolts. H. Install the 2 NEW disc brake pad support plates. Apply disc brake grease to the back of the brake pad support plate. I. Install the front anti-squeal shims. (1) Apply disc brake grease to the anti-squeal shims. (2) Install the anti-squeal shims and the pad wear indicators to each pad. J. Install the 2 front brake pads with anti-squeal shims to the disc brake cylinder mounting.