Download 2019 Honda Fit Remote Engine Start System II Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter. 3. Remove the roof console: • Using a plastic trim tool, remove the left and right lenses. • Remove the roof console, and unplug the vehicle connectors. 4. Release the passenger’s sunvisor from the right sunvisor holder. 5. Remove the right sunvisor holder: • Wrap masking tape around the tip of a flat-tip screwdriver.
• Release the three retaining tabs on the right sunvisor holder. 6. Remove the driver’s sunvisor: • Pivot the driver’s sunvisor downward. • Wrap masking tape around the tip of a flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it toward the door. NOTE: If the retaining tab did not stay pushed in, return the sunvisor to its original position and repeat this step.