Download Toyota Camry 2.2L 4-Cyl Transmission Servicing – AT Removal and Installation – 1. Disconnect negative battery cable. Remove battery and battery tray. Remove air cleaner assembly and air Cleaner case. Disconnect throttle valve cable from throttle body. Remove cover from cruise control Actuator (if equipped). Disconnect electrical connector at cruise control actuator. 2. Raise and support vehicle. Disconnect necessary electrical connectors and ground cables for transaxle Removal. Disconnect shift cable and oil cooler lines at transaxle. Remove starter. 3. Remove front (radiator side) engine mount-to-lower frame assembly bolts/nuts. Remove bolts and Separate power steering pipe from lower frame assembly. 4. Remove the 3 upper transaxle-to-cylinder block bolts. Support engine with hoist. Steering gear assembly Must be supported in place during transaxle removal. Secure steering gear assembly to the engine hoist Using an attaching strap placed at each end of steering gear assembly. 5. Remove front exhaust pipe located between exhaust manifold and rear exhaust pipe. Remove front Wheels. Drain transaxle fluid. Remove axle shafts from transaxle. See fwd axle shafts article in Drive axles.