Home Auto Repair Toyota Celica 1.8L 7A-FE Transmission Servicing – AT Removal & Installation

Toyota Celica 1.8L 7A-FE Transmission Servicing – AT Removal & Installation

105

Download Toyota Celica 1.8L 7A-FE Transmission Servicing – AT Removal and Installation – 1. Disconnect negative battery cable. Remove transaxle oil dipstick and battery. Disconnect throttle cable valve from throttle body. Remover air cleaner assembly. Remove transaxle-to-mount nut from top of transaxle at driver’s side end of transaxle. 2. Remove throttle valve cable mounting bracket and wiring harness clamp bolts from top of transaxle. Remove upper mounting bolt from starter. Remove the 2 upper transaxle-to-cylinder block bolts located at top of transaxle. 3. Remove transaxle oil dipstick tube and “O” ring from transaxle. Raise and support vehicle. Remove lower engine covers. Disconnect necessary electrical connectors and ground cables for transaxle removal. Disconnect oil cooler lines for transaxle. 4. Support engine with hoist. Steering gear assembly must be supported in place during transaxle removal. Secure steering gear assembly to the engine hoist using an attaching strap placed at each end of steering gear assembly. 5. Remove front wheels. Drain transaxle fluid. Remove axle shafts from transaxle. See FWD AXLE SHAFTS article in DRIVE AXLES. 6. Support transaxle with transmission jack.