Home Auto Repair Toyota Celica 2.2L 5S-FE Transmission Servicing – AT Removal & Installation

Toyota Celica 2.2L 5S-FE Transmission Servicing – AT Removal & Installation

149

Download Toyota Celica 2.2L 5S-FE Transmission Servicing – AT Removal and Installation – 1. Disconnect negative battery cable. Remove battery. Disconnect throttle valve cable from throttle body. Remove cruise control actuator (if equipped). Remover air cleaner assembly. 2. Remove transaxle-to-mount bolts/nuts from top of transaxle at driver’s side end of transaxle. Remove starter. Disconnect necessary ground cables and electrical connectors at transaxle. 3. Remove the 3 upper transaxle-to-cylinder block bolts located at top of transaxle. Disconnect oil cooler lines for transaxle. Raise and support vehicle. Remove lower engine covers. 4. Support engine with hoist. Steering gear assembly must be supported in place during transaxle removal. Secure steering gear assembly to the engine hoist using an attaching strap placed at each end of steering gear assembly. 5. Remove front wheels. Drain transaxle fluid. Remove axle shafts from transaxle. See FWD AXLE SHAFTS article in DRIVE AXLES. 6. Support transaxle with transmission jack. Disconnect shift cable at transaxle. Remove rear (firewall side) engine mount through-bolt. Remove front exhaust pipe-to-front exhaust pipe support bracket bolts.