How to Install Front Under Spoilers on 2019 Honda Passport

INSTALLATION 1.Turn the steering wheel fully clockwise. 2.While wearing eye protection, drill the dimple to 6 mm. First, drill with a 3 mm drill bit, and...

How to Install the Fender Flares on a 2019 Honda Passport

INSTALLATION NOTE: • If the vehicle is equipped with splash guards remove them, they cannot be installed with these fender flares. • Be careful not to damage the...

How to Install Engine Block Heater on 2019 Honda Passport

INSTALLATION NOTE: • Always use Honda Genuine Long Life Antifreeze/Coolant Type 2. Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction...

How to Install the Door Visors on a 2019 Honda Passport

Download 2019 Honda Passport Door Visors Installation Instructions - Installing the Front Door Visor 1. Fully open the left front door glass. 2. Peel...

How to Install Door Sill Protection Film on 2019 Honda Passport

Download 2019 Honda Passport Door Sill Protection Film Installation Instructions - Installing the Door Sill Protection Film 1. Open the left front door, and...

How to Install Door Mirror Covers on 2019 Honda Passport

Download 2019 Honda Passport Door Mirror Covers Installation Instructions - 1. Disconnect the negative cable: • Wrap a shop towel around the hood latch....

How to Install Door Handle Films on 2019 Honda Passport

Download 2019 Honda Passport Door Handle Films Installation Instructions - Installing the Door Handle Films 1. Using the alcohol wipe, thoroughly clean the area...

How to Install Door Edge Guards on 2019 Honda Passport

Download 2019 Honda Passport Door Edge Guards Installation Instructions - 1. Identify each door edge guard by holding it up to the door and...

How to Install Door Edge Films on 2019 Honda Passport

Download 2019 Honda Passport Door Edge Films Installation Instructions - 1. Open the left rear door. Peel back the left rear door seal, and...

How to Install Cup Holder Light on 2019 Honda Passport

Download 2019 Honda Passport Cup Holder Light Installation Instructions - 1. Disconnect the negative cable from the battery: • Wrap a shop towel around...

Recent Posts

Popular Posts