Home Tips & Tricks 1997 Toyota Camry LE Sedan 4-Door Steering Gear: Service and Repair Installation

1997 Toyota Camry LE Sedan 4-Door Steering Gear: Service and Repair Installation

67
Download 1. Install PS gear assembly. a. Install the gear assembly from the LH of the vehicle. CAUTION: Do not damage the turn pressure tubes. b. Torque the 2 gear assembly set bolts and nuts to 181 Nm (134 ft. lbs.). NOTE: Lift up the stabilizer bar and install the bolts. 2. Install No.1 fuel tube protector. Install the 2 bolts and nut. 3. Connect stabilizer bar. Torque the 4 bolts to 19 Nm (14 ft. lbs.). 4. Connect pressure feed and return tubes. Using SST 09631 – 22020, connect the tube, then tighten to 32 Nm (24 ft. lbs.). NOTE: – Use a torque wrench with a fulcrum length of 300 mm (11.81 inch). – This torque value is effective in case that SST is parallel to a torque wrench. 5. 6. 7. 8. Connect clamp plate, then tighten the nut to 10 Nm (7 ft. lbs.). Connect intermediate shaft. Connect RH and LH tie rod ends. Position front wheels facing straight ahead. NOTE: